Zum Hauptinhalt wechseln

Dell Alienware 13 R3 Rear-I/O Cover Replacement

Was du brauchst

  1. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Loosen the Screws: Schritt 1, Bild 1 von 1
    • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

    • Loosen the five captive screws that secure the base cover to the computer base.

  2. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Pry the Base Cover: Schritt 2, Bild 1 von 1
    • Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

  3. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Lift the Base Cover: Schritt 3, Bild 1 von 1
    • Lift the base cover off the computer base.

  4. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Disconnect the Battery Cable: Schritt 4, Bild 1 von 1
    • Using a plastic scribe, disconnect the battery cable from the system board.

    • Press and hold the power button for five seconds to ground the system board.

    • Connect the battery cable to the system board.

  5. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Slide the Tabs: Schritt 7, Bild 1 von 1
    • Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

  6. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Tighten the Five Captive Screws: Schritt 8, Bild 1 von 1
    • Tighten the five captive screws that secure the base cover to the computer base.

  7. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Remove the Screws: Schritt 9, Bild 1 von 1
    • Remove the two screws (M2.5x6L) that secure the rear-I/O cover to the palm-rest assembly.

  8. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Using a Plastic Scribe: Schritt 10, Bild 1 von 1
    • Using a plastic scribe, gently release the tabs that secure rear-I/O cover to the computer base.

    • Slide and remove the rear-I/O cover from the computer base.

  9. Dell Alienware 13 R3 Rear-I/O Cover Replacement, Sliding the Rear-I/O: Schritt 12, Bild 1 von 1
    • Slide the NEW rear-I/O cover into the slots on the computer base and snap the rear-I/O cover into place.

    • Replace the two screws (M2.5x6L) that secure the rear-I/O cover to the palm-rest assembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Terrence15

Mitglied seit: 12/18/17

79.031 Reputation

441 Anleitungen geschrieben

Team

RampUP America, Inc. Mitglied von RampUP America, Inc.

Community

42 Mitglieder

1.985 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 6

Insgesamt: 823