Einleitung
If the battery in your Altec Lansing Mini Lifejacket 2 isn't holding a charge or is showing signs of failure, use this guide to replace it.
Was du brauchst
-
-
Use the spudger to remove the eight black pins from the front and back of the wire screens.
-
-
-
Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.
-
-
-
Remove the single 7.8mm Phillips #2 screw from the mounting plate located under the device.
-
Slide the mounting plate out to remove it.
-
-
-
-
Using tweezers, remove the four rubber stoppers in each corner of the rear panel.
-
-
-
Remove the four 13.7mm Phillips #1 screws located underneath the rubber stoppers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
7 weitere Nutzer:innen haben diese Anleitung absolviert.
10 Kommentare
Search for MCR18650 battery. They are available.
Hickisch, I appreciate your guide on replacing this battery, but I beg to differ that replacement batteries are “available.” I keep getting sent batteries with 3-wire connectors instead of 2-wire. Plz send me a link, plz. Gracias.
for the mini life jacket 3, the motherboard is upside down so you need to remove it to unplug the battery.
For the mini life jacket 3 can you send what link you had for the battery?