Zum Hauptinhalt wechseln

DigiTech RP70 Input/Output ¼” Ports Replacement

Was du brauchst

  1. DigiTech RP70 Input/Output ¼” Ports  Replacement, Motherboard: Schritt 1, Bild 1 von 2 DigiTech RP70 Input/Output ¼” Ports  Replacement, Motherboard: Schritt 1, Bild 2 von 2
    • Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.

    • Remove the four 8mm Phillips #0 screws located on the back panel.

  2. DigiTech RP70 Input/Output ¼” Ports  Replacement: Schritt 2, Bild 1 von 2 DigiTech RP70 Input/Output ¼” Ports  Replacement: Schritt 2, Bild 2 von 2
    • Remove the back panel to expose the motherboard.

  3. DigiTech RP70 Input/Output ¼” Ports  Replacement: Schritt 3, Bild 1 von 1
    • Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

  4. DigiTech RP70 Input/Output ¼” Ports  Replacement: Schritt 4, Bild 1 von 1
    • Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

  5. DigiTech RP70 Input/Output ¼” Ports  Replacement, Input/Output ¼” Ports: Schritt 5, Bild 1 von 2 DigiTech RP70 Input/Output ¼” Ports  Replacement, Input/Output ¼” Ports: Schritt 5, Bild 2 von 2
    • Desolder the back of the motherboard where the damaged input/output port is located.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 301