Einleitung
The InFocus X2 projector’s lamp can become burned out, resulting in a picture that is blacked out on one side. This guide will describe how to access the lamp and replace the burned-out part with a new one.
Was du brauchst
-
-
Insert the Jimmy into one of the two notches on the lamp door's top edge.
-
Then use light force on the Jimmy to pry the latch away from the door.
-
If necessary, insert the Jimmy into the second latch and separate it from the projector.
-
Remove the door away from the projector by hand.
-
-
-
Gently disconnect the lamp from the projector by using your thumb and forefinger to pinch on the white tab on the plug.
-
Then pull the plug away from the projector.
-
-
-
-
Use a Phillips #4 screwdriver or driver with the Phillips #4 head to unscrew the two 0.6 mm diameter brass screws from the lamp's housing.
-
-
-
Pull on the bottom plastic tab and remove the lamp by hand.
-
To reassemble your device, follow these instructions in reverse order.
Caution: The old bulb contains mercury. Please recycle it in a safe and appropriate manner. Look for your local recycling information at https://earth911.com/
To reassemble your device, follow these instructions in reverse order.
Caution: The old bulb contains mercury. Please recycle it in a safe and appropriate manner. Look for your local recycling information at https://earth911.com/
Angehängte Dokumente
Team
UMass Dartmouth, Team 1-3, Gulbrandsen Fall 2013 Mitglied von UMass Dartmouth, Team 1-3, Gulbrandsen Fall 2013
UMASSD-GULBRANDSEN-F13S1G3
3 Mitglieder
10 Anleitungen geschrieben
