Zum Hauptinhalt wechseln

Wie man ausgeleierte Inbus-Senkschrauben ausdreht

Was du brauchst

  1. Wie man ausgeleierte Inbus-Senkschrauben ausdreht, Wie man ausgeleierte Inbus-Senkschrauben ausdreht: Schritt 1, Bild 1 von 1
    • Schneide einen Schlitz in den Kopf.

    • Setze einen Flachschraubendreher am Schlitz an und hämmere leicht dagegen, so dass sich die Schraube gegen den Uhrzeigersinn lockert.

    • Drehe sie dann ganz heraus.

Ziellinie

44 weitere Nutzer:innen haben diese Anleitung absolviert.

Besonderer Dank geht an diese Übersetzer:innen:

en de

100%

VauWeh hilft uns, die Welt in Ordnung zu bringen! Wie kann ich mithelfen?
Hier starten ›

Wolfgang

Mitglied seit: 02/17/12

597 Reputation

2 Anleitungen geschrieben

6 Kommentare

Use the same technique for Philips or crosshead screws.

Use a grinding / cutting disk, not a saw blade. Apply the rotating cutting disk gently, do not force or it will break.

If this is a toughened steel or stainless steel bolt (much tougher), it will be best to use a reinforced cutting disk.

Use a dusk mask to avoid breathing the dusk from the disk !

(No, I don't usually, but I should !)

Frank B - Antwort

While this works it is very difficult to not ruin the material around the bolt.

What I do is use a torx bit. size one up that is slightly larger then the hole and then firmly tap it in. atttach your drive handle a turn slowly while pushing down. this will normally break it free.

Also before your get to this point try putting your allen key in the hole and smack it with a hammer. sometimes the force of the hit will cause the metal to "break" enough that the allen screw wont strip.

Jamie Mcguire -

There are also specifically designed screw extractors made for this. These tools are generally two-sided: one side is used to drill the hole, while the other is inserted to extract. If the process works, the surrounding area is undamaged.

Karl Kaufmann - Antwort

Use another Allen bolt to weld over it and then you can easily remove the Allen bolt with the help of Allen key

Tushar Pednekar - Antwort

And if for any reason if you can't weld then just drill the head of the Allen bolt so it's shears off. And then u can easily remove the rest

Tushar Pednekar - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 9

Letzte 7 Tage: 92

Letzte 30 Tage: 406

Insgesamt: 257,910