Zum Hauptinhalt wechseln

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure

Was du brauchst

  1. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure, Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 1, Bild 1 von 1
    • Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

  2. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 2, Bild 1 von 2 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 2, Bild 2 von 2
    • Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

  3. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 3, Bild 1 von 1
    • Slide the battery upward to remove.

  4. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 4, Bild 1 von 2 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 4, Bild 2 von 2
    • Remove the rubber plug located near the camera by gently prying upward with your fingers.

    • Gently lift the camera shield after removal of the rubber plug.

  5. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 5, Bild 1 von 2 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 5, Bild 2 von 2
    • Pry the remaining panel to loosen its contact to the phone using a spudger.

    • Slide the panel upward to remove it completely.

    • These steps will require a slight appliance of force.

  6. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 6, Bild 1 von 1
    • Slide the aerial upward to remove it.

  7. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 7, Bild 1 von 2 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 7, Bild 2 von 2
    • Remove the four screws located at each corner of the device.

  8. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 8, Bild 1 von 2 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 8, Bild 2 von 2
    • Gently lift and remove the front panel of the phone after removing the screws.

  9. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 9, Bild 1 von 3 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 9, Bild 2 von 3 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 9, Bild 3 von 3
    • This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.

    • Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.

    • Gently pull the ribbon from the circuit.

    • Remove the now disconnected screen.

  10. Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 10, Bild 1 von 3 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 10, Bild 2 von 3 Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 10, Bild 3 von 3
    • Remove the keyboard by slowly pulling it away from the circuit board.

    • There are no direct connections between the keyboard and phone.

    • These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer:innen haben diese Anleitung absolviert.

Team

University of Maine, Team 1-13, Diaz Fall 2013 Mitglied von University of Maine, Team 1-13, Diaz Fall 2013

UMAINE-DIAZ-F13S1G13

3 Mitglieder

14 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 5

Letzte 30 Tage: 14

Insgesamt: 3,504