Zum Hauptinhalt wechseln

Apple Studio Display M2454 USB port replacement

Was du brauchst

  1. Apple Studio Display M2454 USB port replacement, USB Ports: Schritt 1, Bild 1 von 1
    • The USB ports are located on the back side of the monitor, below the plastic cover and metallic panel; on the lower left hand side.

    • The first step is to remove the plastic cover panel.

    • To do so, remove the three 2mm hex screws on the monitor's stand, as well as the four 2mm hex screws located on the four corners of the back plastic cover panel.

    • After removing the mentioned screws, it is possible to take off the panels and began examining the inner components. Make sure main cable i pulled through plastic port.

    • For additional help removing the back panel, refer to the repair guide for the LCD Main Board.

  2. Apple Studio Display M2454 USB port replacement: Schritt 2, Bild 1 von 1
    • Remove the three screws holding metal plate, one on the top in the middle, and two at the bottom by the main cable.

    • Push the metal plate towards bottom of the monitor to release it from clips and remove.

    • After popping off (removing) metal plate, you can now see all inner components, where the USB connector is on left side.

  3. Apple Studio Display M2454 USB port replacement: Schritt 3, Bild 1 von 1
    • There are two leads from the USB port to the LCD Main Board.

    • Remove the two white connectors by raising the tabs on top gently by hand or using a small pry tool.

    • Pull connectorss away from the board while tabs are lifted.

    • Be gentle with tabs, they break easily.

  4. Apple Studio Display M2454 USB port replacement: Schritt 4, Bild 1 von 1
    • Remove the two phillips head screws on the sides of USB port, using #2 phillips head screwdriver.

  5. Apple Studio Display M2454 USB port replacement: Schritt 5, Bild 1 von 1
    • Remove the single screw on the cable hold-down, using #2 phillips head screwdriver.

  6. Apple Studio Display M2454 USB port replacement: Schritt 6, Bild 1 von 1
    • Finally pull USB port away from monitor.

    • To insert the new USB port, simply follow these steps in reverse using your new part.

Ziellinie

Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.

Dylan Perry

Mitglied seit: 01/20/10

177 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 13-27, Maness Winter 2010 Mitglied von Cal Poly, Team 13-27, Maness Winter 2010

CPSU-MANESS-W10S13G27

4 Mitglieder

9 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 9

Insgesamt: 4,292