Einleitung
Removing the back panel from the Toshiba AT1304T
If you can't get a hold of a Torx 6 Security Screwdriver, a small flathead can be used as a substitute
Was du brauchst
-
-
Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
-
-
-
-
With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
-
-
-
If needed, use the flathead screwdriver to gently pry the panel from the phone.
-
Using your fingers, lift the panel from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 16-6, Maness Spring 2010 Mitglied von Cal Poly, Team 16-6, Maness Spring 2010
CPSU-MANESS-S10S16G6
4 Mitglieder
16 Anleitungen geschrieben
