Einleitung
This guide is a step by step process to remove the inner back cover of the phone. It is a preliminary step, to gain access to the inside elements of the phone.
Was du brauchst
-
-
Turn off the phone.
-
Check if there is a microSD card in the slot behind the door on the side. If so, remove it by first pushing it in, then pulling it out.
-
Position the phone so that the back side is in view.
-
-
-
Remove the back battery cover.
-
Apply pressure on the cover while simultaneously sliding the cover downward.
-
-
-
Insert the iPod opening tool between the base of the phone and the phone battery.
-
Position the phone so that the battery won't fall out of the phone.
-
Carefully lift the battery out of the phone.
-
-
-
-
Turn the phone so that the back of the phone is facing forward.
-
The picture to the left shows the location of the plastic tabs that attach to the upper cover of the phone.
-
-
-
Place the iPod opening tool under the tabs near the top of the phone.
-
Slide the iPod Opening Tool upwards.
-
This will pop the tabs and release the upper part of the phone.
-
-
-
Place the iPod opening tool at the top area of the bottom section of the phone (indicated in picture).
-
Lift the iPod opening tool to pop open the clips.
-
This will release the upper back cover of the phone.
-
-
-
Push upward on the top back cover using two thumbs.
-
This will remove the top back cover from the phone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 26-30, Regan Spring 2010 Mitglied von Cal Poly, Team 26-30, Regan Spring 2010
CPSU-REGAN-S10S26G30
4 Mitglieder
17 Anleitungen geschrieben
