Einleitung
Step-by-step guide to replacing your phone's keypad buttons.
Was du brauchst
-
-
Flip the phone over so the back cover is facing up.
-
Using either a finger or a spudger, press the button located near the top of the phone by the antenna.
-
-
-
Pry up the back plate from the phone.
-
Push the button near the bottom of the battery using either your finger or the spudger to release the battery.
-
-
-
Using a T6 Torx screwdriver, remove the four screws from the back of the phone.
-
-
-
-
Place logic board on front cover.
-
Unsnap orange wire that connects the logic board to keypad sensor to allow the logic board to move freely.
-
-
-
Once logic board is removed lift the green keypad sensor for the front plate.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 30-40, Garner Spring 2010 Mitglied von Cal Poly, Team 30-40, Garner Spring 2010
CPSU-GARNER-S10S30G40
4 Mitglieder
14 Anleitungen geschrieben
