Zum Hauptinhalt wechseln

Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement

Was du brauchst

  1. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing back panel: Schritt 1, Bild 1 von 2 Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing back panel: Schritt 1, Bild 2 von 2
    In diesem Schritt verwendetes Werkzeug:
    Flathead 1.5 mm Screwdriver
    $5.49
    Kaufen
    • Remove the back panel of the device by unscrewing the single #8 11.6 mm Flathead screw on the back of the device.

  2. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing batteries: Schritt 2, Bild 1 von 1
    • Remove the 3 AAA batteries from the device.

  3. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing back half of device: Schritt 3, Bild 1 von 2 Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing back half of device: Schritt 3, Bild 2 von 2
    • Unscrew the other 4, #8 11.6 mm Phillips Head screws to remove the entire back half of the device.

    • Pull apart the device once screws are loose, splitting the device in half.

  4. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Positioning device: Schritt 4, Bild 1 von 1
    • Keeping all wires connected to their attachments, place the front half of the device face down.

  5. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Inspecting PCB: Schritt 5, Bild 1 von 1
    • Inspect the printed circuit board for any breaks or cracks.

  6. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing PCB: Schritt 6, Bild 1 von 2 Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Removing PCB: Schritt 6, Bild 2 von 2
    • Remove the 2, #8 11.7 mm Phillips Head screws as well as the 2, #8 7.5 mm screws on the printed circuit board.

  7. Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Replacing PCB: Schritt 7, Bild 1 von 2 Justin Bieber Concert Microphone Printed Circuit Board (PCB) Replacement, Replacing PCB: Schritt 7, Bild 2 von 2
    • Disconnect all wires from the PCB

    • Remove the damaged PCB from the microphone

    • Place new PCB in the Justin Bieber Concert Microphone.

    • Connect all the wires to the new PCB using this soldering guide.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Mike Seyman

Mitglied seit: 10/19/14

437 Reputation

4 Anleitungen geschrieben

Team

Baylor, Team 4-1, Williams Fall 2014 Mitglied von Baylor, Team 4-1, Williams Fall 2014

BU-WILLIAMS-F14S4G1

3 Mitglieder

4 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 289