Was du brauchst
-
-
Turn off camera using the power button on the top of the camera.
-
On the bottom of the camera, open the battery door and remove the battery.
-
-
-
On the top cover, remove the two screws from under the metal tabs that are used to attach the camera straps.
-
-
-
Remove 1 screw from the left side of the camera.
-
Inside the rubber door, remove the two black screws.
-
-
-
Remove the screw in the center of the viewfinder focus knob located to the right of the eyepiece.
-
-
-
Remove the two black screws on the front of the camera just above the lens mounting ring.
-
NOTE: Do not remove any of the silver screws on the lens mount ring. This could cause problems with auto focussing features.
-
-
-
-
Using the spudger and plastic opening tool, pry the back of the camera loose.
-
Remove the ribbon connector on the lower left hand side of the circuit board.
-
-
-
Using the spudger and plastic opening tool, pry the bottom of the front panel of the camera over the tripod mount.
-
-
-
Remove the ribbon connector on the upper right hand side of the circuit board.
-
Remove the microphone connection on the upper left hand side of the circuit board.
-
-
-
On the lower left side on the front of the camera, disconnect the red and yellow wires from the circuit board.
-
-
-
Now that the top assembly is free, this exposes another screw on the right side of the mirror box.
-
Remove this screw.
-
Remove the orange ribbon cable.
-
-
-
Remove the viewfinder assembly from the camera.The screws that hold the eyepiece in place are accessible. Remove these 3 screws from the rear face of the eyepiece. Two screws are located at the bottom and one screw is located on top.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.