Einleitung
Use this guide to replace a defective Motherboard.
Was du brauchst
-
-
Insert plastic opening tool under back cover.
-
Apply pressure on tool while using a downward motion to pop off back cover.
-
-
-
Insert plastic opening tool under back cover.
-
Pry the top cover upward to remove it from the phone.
-
-
-
Remove the four 3.8mm Phillips #000 screws securing the top cover to the back assembly.
-
-
-
Insert plastic opening tool under top cover.
-
Using hand slide top cover away from phone.
-
-
-
-
Remove the four 3.8mm Phillips #000 screws securing the back assembly to the phone.
-
-
-
Insert plastic opening tool between back assembly and phone.
-
Pry the back assembly away from phone.
-
-
-
With plastic opening tool continue prying around the edge of the back assembly.
-
-
-
Insert the pointed end of a spudger into the gap in the round housing frame.
-
Using spudger to remove vibrator remove from the adhesive.
-
-
-
Use the flat end of a spudger to disconnect the camera assembly cable.
-
-
-
Insert the spudger under each corner ribbon cable and lift them out of the way.
-
Insert a plastic pry tool into the gap between motherboard and base of phone
-
-
-
Tilt the motherboard up carefully.
-
Use a spudger to pry the connector from the socket on the motherboard.
-
Lift motherboard from frame.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.