Einleitung
This step-by-step guide illustrates how to remove and replace the back case of a Pocket PC.
Was du brauchst
-
-
While sliding the silver release tab up, simultaneously lift the cover up from the left side.
-
-
-
-
Remove the four silver screws using the T5 Torx Screwdriver (T5 x .25 in).
-
-
-
Remove the single black screw that is located beneath the HP sticker with the T5 Torx Screwdriver.
-
-
-
Next, use your plastic removal tool to separate the gray back from the black center piece.
-
For better results, start the separation at the corner piece.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.