Einleitung
If you're having scanning issues as a result of a faulty sensor bar, this is where you will want to begin.
To replace the sensor bar in the Canon CanoScan N670U, you must:
- Remove the two plastic bars that hold the glass scanner bed.
- Set aside the scanner bed.
- Loosen the belt from the plastic hook.
- Remove the sensor bar for replacement.
Was du brauchst
-
-
Open up your Canon CanoScan N670U to an upright position.
-
-
-
Turn your device so that you're facing the long side of the Canon CanoScan N670U.
-
Locate the small crevice between the plastic components of the scanner bed and the scanner base.
-
-
-
Carefully insert a metal spudger tool in the crevice and slowly cut through the adhesive between the plastic components.
-
-
-
Once the adhesive strip is sliced through, the plastic bar that is attached should release. Set aside the plastic bar.
-
-
-
-
Use your hands or a metal spudger tool to push the plastic bar at the bottom of the glass scanner bed forward until you can't push it any farther.
-
-
-
Insert the metal spudger tool underneath the glass scanner bed. The front of the scanner bed should be resting on top of the tool.
-
-
-
Locate the small plug where the white strip of cable is connected to.
-
Unfurl the cable strip if it's tucked in.
-
-
-
Gently use tweezers or your fingers to rock the cable back and forth to disconnect the it.
-
-
-
Locate the small metal spring behind the front buttons of the Canon CanoScan N670U.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
USF Sarasota-Manatee, Team 1-1, Stewart Fall 2015 Mitglied von USF Sarasota-Manatee, Team 1-1, Stewart Fall 2015
USFSM-STEWART-F15S1G1
5 Mitglieder
20 Anleitungen geschrieben
