Einleitung
Some things to consider before you work on the Sony Cyber-shot DSC W800 to replace the LCD Screen:
- The LCD Screen is an integral part of the device and any improper handling can cause issues in other parts of the camera.
- Be cautious when removing ribbon wires.
- Be sure to keep track of all pieces that are taken apart.
Was du brauchst
-
-
Using the Spudger, remove the back panel from the device.
-
The loose piece circled in the picture will most likely fall off the camera housing.
-
-
-
-
Remove the two 2.15mm Phillips #000 screws from the circuit board.
-
Gently pull on the ribbon wire from ZIF connector with the tweezers to remove the button board.
-
-
-
Remove the four 3.75 mm Phillips #000 screws from the LCD back panel.
-
-
-
Lift the back panel and separate the LCD Screen by prying it up.
-
Remove the back panel.
-
-
-
Gently pull on the ribbon wire disconnecting from the ZIF connector (connecting the LCD screen to the motherboard) with the tweezers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
USF Tampa, Team 17-5, Blackwell Winter 2016 Mitglied von USF Tampa, Team 17-5, Blackwell Winter 2016
USFT-BLACKWELL-W16S17G5
5 Mitglieder
5 Anleitungen geschrieben
