Zum Hauptinhalt wechseln

Dell Latitude X300 Palm Rest/Track Pad Replacement

Was du brauchst

  1. Dell Latitude X300 Palm Rest/Track Pad Replacement, Battery: Schritt 1, Bild 1 von 1
    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

  2. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 2, Bild 1 von 1
    • Slide the battery out of the laptop.

  3. Dell Latitude X300 Palm Rest/Track Pad Replacement, Keyboard: Schritt 3, Bild 1 von 1
    • Remove the four 4 mm Phillips #0 screws from the bottom of the laptop.

  4. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 4, Bild 1 von 2 Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 4, Bild 2 von 2
    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

  5. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 5, Bild 1 von 1
    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

  6. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 6, Bild 1 von 1
    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

  7. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 7, Bild 1 von 1
    • Remove the flexible ribbon from the ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

  8. Dell Latitude X300 Palm Rest/Track Pad Replacement, Palm Rest/Track Pad: Schritt 8, Bild 1 von 1
    • Position the laptop so that the bottom is facing upward.

    • Remove the three 4 mm Phillips #0 screws holding the bottom of the palm rest.

  9. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 9, Bild 1 von 1
    • Return the laptop to proper position and open the screen.

    • Remove the six 4 mm Phillips #0 screws holding in the palm rest.

  10. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 10, Bild 1 von 1
    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

  11. Dell Latitude X300 Palm Rest/Track Pad Replacement: Schritt 11, Bild 1 von 1
    • Lift up on the small ZIF connector and remove the ribbon.

    • If the ribbon seems stuck, gently wiggle it to remove. Do not pull the ribbon with great force.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Thomas Wong

Mitglied seit: 01/20/12

23 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 11-20, Maness Winter 2012 Mitglied von Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Mitglieder

7 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 858