Repariere deine Sachen Community Store

NuVision TM800A510L Screen Replacement

Einleitung

This repair may take some time because you have to remove everything in the device in order to access the screen and adhesive is used to keep the screen attached to its frame.

Was du brauchst

  1. NuVision TM800A510L Screen Replacement, Screen: Schritt 1, Bild 1 von 2 NuVision TM800A510L Screen Replacement, Screen: Schritt 1, Bild 2 von 2

    • Use a Heat Gun to heat the sides of the device and loosen the adhesive.

    • Heat the adhesive/device to just barely too hot to touch.

    • Pry up the the back of the device.

    • This process works best if you go one side at a time.

    Übersetzen

  2. NuVision TM800A510L Screen Replacement: Schritt 2, Bild 1 von 1
    Übersetzen

  3. NuVision TM800A510L Screen Replacement: Schritt 3, Bild 1 von 1

    • Peel this connector off the device.

    • This is basically just a sticker, but go slow so you don't tear the connector.

    Übersetzen

  5. NuVision TM800A510L Screen Replacement: Schritt 4, Bild 1 von 1

    • Slowly pull the speaker out of its bed.

    • The speaker piece is glued down.

    Übersetzen

  6. NuVision TM800A510L Screen Replacement: Schritt 5, Bild 1 von 2 NuVision TM800A510L Screen Replacement: Schritt 5, Bild 2 von 2

    • If you have not done so already, de-solder the boards from the device.

    • De-soldering the wires right now makes sure none of the wires are damaged or broken when we move the components.

    Übersetzen

  7. NuVision TM800A510L Screen Replacement: Schritt 6, Bild 1 von 1

    • The touch screen should lift right out of the device.

    Übersetzen

  8. NuVision TM800A510L Screen Replacement: Schritt 7, Bild 1 von 1

    • Use the Heat Gun to heat the adhesive between the screen and edge protector.

    • Pry the two pieces apart.

    • Be careful of the circuit ribbon for the touch screen when prying the two pieces apart. The ribbon threads through both pieces.

    • Remember: Heating the device to 'almost to hot to touch' makes the process easier to work with.

    • Tip: Try the heating & prying process on one side of the device at a time.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 9

Insgesamt: 2,388