Zum Hauptinhalt wechseln

Canon EOS Rebel G Strap Anchors Replacement

Was du brauchst

  1. Canon EOS Rebel G Strap Anchors Replacement, Front Panel: Schritt 1, Bild 1 von 1
    • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

  2. Canon EOS Rebel G Strap Anchors Replacement: Schritt 2, Bild 1 von 2 Canon EOS Rebel G Strap Anchors Replacement: Schritt 2, Bild 2 von 2
    • Using your finger, peel back the textured grip so the components are separated.

  3. Canon EOS Rebel G Strap Anchors Replacement: Schritt 3, Bild 1 von 3 Canon EOS Rebel G Strap Anchors Replacement: Schritt 3, Bild 2 von 3 Canon EOS Rebel G Strap Anchors Replacement: Schritt 3, Bild 3 von 3
    • Using the flat end of a spudger, loosen the connection between the front panel and the device.

    • Remove the front panel using your hands.

  4. Canon EOS Rebel G Strap Anchors Replacement, Top Panel: Schritt 4, Bild 1 von 1
    • Turn Camera over.

    • Using a #00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws located on either side of the viewfinder.

  5. Canon EOS Rebel G Strap Anchors Replacement: Schritt 5, Bild 1 von 1
    • Using a #00 Phillips screw driver, unscrew the one 5.7 mm Phillips screw located next to the LCD screen.

  6. Canon EOS Rebel G Strap Anchors Replacement: Schritt 6, Bild 1 von 1
    • Lay the camera on its back.

    • Unsolder the flash connection from the motherboard as noted by the blue circle.

  7. Canon EOS Rebel G Strap Anchors Replacement: Schritt 7, Bild 1 von 3 Canon EOS Rebel G Strap Anchors Replacement: Schritt 7, Bild 2 von 3 Canon EOS Rebel G Strap Anchors Replacement: Schritt 7, Bild 3 von 3
    • Remove the top panel by lifting it from the back, pushing it forward over the camera and letting it rotate down in front of the camera.

  8. Canon EOS Rebel G Strap Anchors Replacement, Strap Anchors: Schritt 8, Bild 1 von 1
    • Unscrew the 6.8 Phillips screw that holds the strap anchor by the LCD.

  9. Canon EOS Rebel G Strap Anchors Replacement: Schritt 9, Bild 1 von 1
    • Unscrew the screws that hold the remaining strap anchor.

    • Two 4.9 mm Phillips screws

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kyle Reis

Mitglied seit: 04/02/12

52 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 14-9, Forte Spring 2012 Mitglied von Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 Mitglieder

36 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 8

Insgesamt: 1,175