Einleitung
Use this guide to replace your headset's motherboard
Was du brauchst
-
-
Flip the headset face down.
-
Squeeze both sides of the battery cover.
-
While squeezing, pull the cover up slowly to remove it.
-
-
-
Locate and detatch the white connector that connects the wires of the battery to the wires of the headset.
-
-
-
Use a hairdryer or heat gun to melt the adhesive along the crevice that joins the black and silver components.
-
Apply additional heat at the tip of the microphone.
-
-
-
After heating the headset, use the plastic opening tool to carefully pry the black cover from the headset.
-
-
-
-
Use the heat gun to melt the adhesive connecting the headset face to the speaker casing.
-
Use the plastic opening tool to separate the speaker casing from the headset face.
-
-
-
Flip the device over.
-
Use a soldering iron to remove the solder that holds the wires to the motherboard.
-
-
-
Using a blow dryer or a heat gun, heat the crevice to melt the adhesive between the plastic covers.
-
Using a plastic opening tool, prop open the edges.
-
Gently pull the black speaker casing up to remove it.
-
-
-
Use the heat gun or blow dryer to melt the glue that connects the wires to the headset's motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 17-29, Amido Spring 2012 Mitglied von Cal Poly, Team 17-29, Amido Spring 2012
CPSU-AMIDO-S12S17G29
4 Mitglieder
7 Anleitungen geschrieben
