Einleitung
Replace your modem to regain dial-up internet access.
Was du brauchst
-
-
Use your thumbs to push the two battery retaining tabs away from the battery.
-
The battery should pop up enough to rotate it toward yourself and lift it out of the lower case.
-
-
-
Remove the three 2.3 mm Phillips screws securing the memory cover to the lower case.
-
-
-
Lift the memory cover slightly and pull it toward yourself to remove it from the lower case.
-
-
-
Remove the following ten screws:
-
Two 14.7 mm shouldered Phillips.
-
Three 12.3 mm Phillips.
-
One 3.8 mm T8 Torx.
-
One 6.8 mm T8 Torx.
-
Three 1.3 mm Phillips.
-
-
-
Use your fingernails to separate the ZIF cable lock away from its socket. (Move the two brown bits down 1mm)
-
-
-
-
Remove the four 3.4 mm Phillips screws from the DVI connector side of the PowerBook.
-
-
-
Starting near the display, lift the upper case straight up off the lower case, minding any cables that may get caught.
-
-
-
If necessary, peel back the strip of aluminum tape covering the modem cable.
-
-
-
Use the flat end of a spudger to pry the modem cable connector up off the modem.
-
-
-
Use a 4 mm nut driver to remove the two nuts securing the modem to the PC card cage.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.