Einleitung
The purpose of this guide is to communicate steps on how to replace or repair the power switch on a ColecoVision.
Was du brauchst
-
-
Flip the ColecoVision over with the pegs facing the ceiling.
-
Remove the eight 15mm screws holding the bottom of the ColecoVision in place using the Phillips #1 screwdriver.
-
-
-
Carefully remove the bottom of the ColecoVision out of the top.
-
I would recommend running a metal spudger along the rim of the case to remove the bottom.
-
-
-
-
Remove the two 15 mm screws holding the casing in place using the Phillips #1 screwdriver.
-
-
-
Using a Phillips #1 screwdriver, remove the two 15mm screws on the motherboard.
-
Pull the entire motherboard towards the back of the system and carefully lift the entire motherboard.
-
-
-
Flip the motherboard over.
-
Using a soldering iron, carefully desolder the power switch from the motherboard.
-
-
-
Wait for power switch to cool down.
-
Turn the motherboard over upright.
-
Carefully lift up the power switch to completely remove it from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
UW Tacoma, Team S1-G2, Rose Fall 2018 Mitglied von UW Tacoma, Team S1-G2, Rose Fall 2018
UWT-ROSE-F18S1G2
4 Mitglieder
12 Anleitungen geschrieben
