Newport HT70 Air Inlet Filter Replacement

Einleitung

According to the service manual the Air Intake Filter should be checked weekly while in use. In some environments, it may need to be checked more often. The filter should be replaced when the majority of the filter surface area is no longer white. Air Intake Filters are not reusable.

PLEASE NOTE: This repair guide was developed by the iFixit team based on Newport's own service manual. Neither iFixit nor this repair guide is endorsed by or affiliated with Newport.

Replacing the air inlet filter is discussed in:

chapter 8-3 “Cleaning and Maintenance - Air Intake Filter” of user manual
chapter 5-7 “Service and Repair - Air Inlet Filter” of service manual

Schritt 1 shut down the ventilator

Newport HT70 Air Inlet Filter Replacement, shut down the ventilator: Schritt 1, Bild 1 von 3

Newport HT70 Air Inlet Filter Replacement, shut down the ventilator: Schritt 1, Bild 2 von 3

Newport HT70 Air Inlet Filter Replacement, shut down the ventilator: Schritt 1, Bild 3 von 3

The momentary-type power switch is located on the left side rear of the ventilator along the bottom edge. Press the power switch once.
A message appears in the screen that prompts you to Press Accept to Shutdown or Press Cancel to Ignore.
Pressing the Accept button will power off the ventilator.
Pressing Cancel will return the ventilator to its previous state.
Press Alarm Silence to silence the Shut Down alarm.

Übersetzen

Schritt 2 disconnect from power

Disconnect the ventilator from the AC power.

Übersetzen

Schritt 3 remove air filter cover

Newport HT70 Air Inlet Filter Replacement, remove air filter cover: Schritt 3, Bild 1 von 3

Newport HT70 Air Inlet Filter Replacement, remove air filter cover: Schritt 3, Bild 2 von 3

Newport HT70 Air Inlet Filter Replacement, remove air filter cover: Schritt 3, Bild 3 von 3

The inlet air filter is located on the right-hand side of the device.
Turn the knurled screws counter-clockwise to remove.
Slide the inlet filter cover assembly toward the back of the device and lift it out.
Remove the Air Inlet Filter Gasket by carefully pulling it away from the side of the device.

Übersetzen

Schritt 4 replace filter

Newport HT70 Air Inlet Filter Replacement, replace filter: Schritt 4, Bild 1 von 1

Replace the air inlet filter.

Übersetzen

Schritt 5 place back gasket

The service manual makes the following note: To reattach Air Inlet Filter Gasket, use adhesive NMI part number ADH110P. Apply the adhesive to the rear surface of the gasket avoiding the slotted areas. Align the tab in the gasket with the slot on the device and press firmly and allow curing overnight before returning to service.

Übersetzen

Schritt 6 place back air filter cover

Newport HT70 Air Inlet Filter Replacement, place back air filter cover: Schritt 6, Bild 1 von 1

Slide the air filter cover back on.
Turn the knurled screws clockwise to insert.

Übersetzen

Abschluss

Connect the ventilator back to the AC power.
Turn the ventilator back on into standby mode by pressing the power switch once.
While in standby mode you can make settings changes and perform the Circuit Check prior to ventilation.

Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.