Einleitung
Replacing the front buttons on the display.
Was du brauchst
-
-
Lay the display facing down with the stand away from you.
-
Remove the three size 2.0 hex screws on the swing arm and remove the swing arm as well as the plastic shield under it.
-
-
-
Remove the size 2.5 hex screws from each corner that connects the panels to the display and remove them.
-
-
-
Rotate the display so the legs of the display are now facing you
-
Grip the top of the clear panel and lift it upwards, and pull the ADC cable through the hole.
-
-
-
Remove the grey back panel by lifting the bottom and pulling the ADC cable through the hole.
-
-
-
The next layer will be a shiny metal panel, which might have some stickers. Make sure to remove these stickers.
-
-
-
-
Now locate and remove the lone Phillips screw holding the EMI shield to the display
-
-
-
Now that the screw has been removed, slide the panel towards your body and lift it out.
-
-
-
Using the spudger, remove the four black panel covers on the edges of the display.
-
-
-
Remove the outer frame and and pull the cables through the hole. Flip the frame upside down.
-
-
-
The red highlighted box is the power button
-
The teal highlighted box is the brightness button
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.