Einleitung
Replace the LCD in your HP Pavilion dv6000.
Was du brauchst
-
-
Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.
-
Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.
-
-
-
Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.
-
-
-
-
Remove the two screws (5.8mm) on either side of the LCD near the hinge. Remove the screws on the outermost side first.
-
-
-
Hold on to the LCD screen to prevent it from falling over and remove the two 3.58mm screws on the sides at the bottom.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
15 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Cal Poly, Team 21-33, Regan Fall 2010 Mitglied von Cal Poly, Team 21-33, Regan Fall 2010
CPSU-REGAN-F10S21G33
4 Mitglieder
12 Anleitungen geschrieben
Ein Kommentar
after replacing my cracked screen the back light does not show again
