Einleitung
Bevor du mit der Reparatur anfängst, sei dir bewusst, dass du durch den Kondensator des Kamerablitzes einen Schock bekommen kannst. Stelle auch sicher, dass du geerdet bist, bevor du in die Nähe bzw am Motherboard der Kamera arbeitest, ansonsten läufst du Gefahr, eine statische Entladung an wichtige Komponenten abzugeben.
Was du brauchst
-
-
Drücke das Objektiv hinein und entferne die beiden AA-Batterien.
-
-
-
Entferne die Schrauben an der Unterseite der Kamera mit einem kleinen #00 Kreuzschlitzschraubendreher. Dann entferne die Schrauben rundum die Kamera.
-
Wenn alle Schrauben entfernt wurden, hebele die Front vorsichtig auf. Bedenke, dass es eine Feder gibt, die die Front und die Hauptplatine miteinander verbinden. Pass also auf die Spannung der Feder auf.
-
-
-
-
Finde die vier Schrauben an den Ecken der Objektiveinheit und entferne sie, um das Objektivgehäuse vom Hauptrahmen zu lösen. Behalte die Schrauben, um sie im nächsten Schritt zu verwenden.
-
-
-
Entferne die Objektiveinheit vom Hauptrahmen der Kamera.
-
Besorge das Ersatzteil, um den Austausch durchzuführen.
-
Um dein Gerät wieder zusammenzubauen, befolge die Anleitung in umgekehrter Reihenfolge.
Um dein Gerät wieder zusammenzubauen, befolge die Anleitung in umgekehrter Reihenfolge.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
8 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
100%
Diese Übersetzer:innen helfen uns, die Welt zu reparieren! Wie kann ich mithelfen?
Hier starten ›
13 Kommentare
the lens covers on my lens broke (the small black pieces that cover the lenses) and i am unable to put back on, will this affect my camera and pictures because of the ex poser?
When I dropped my instax mini 8, none of the lense pieces broke, they just fell apart, I just need to puzzle them back together. Can you make a tutorial to put the yellow and black parts in the lense back together?
My daughter dropped her camera and the round, hard plastic part that goes over the lens fell out along with a black piece that has four prongs. There is also a spring attached at a section that would look like 4-5 o'clock if looking at the camera head on. I am not sure where the other end of spring attaches to. Please help
I too am having the same problem as the people in the posts above. Is there a solution somewhere? Thanks
I followed this tutorial but when I initally took the case apart a small rectangular piece fell out and I'm not sure where it should go. The piece has a hole which is set to one side, and a slight groove and arch. I can't see the piece on any of the tutorials. Can anyone help? Thanks