Zum Hauptinhalt wechseln

Prerequisite

Grundständige Anleitung
Dies ist eine grundständige Anleitung, die nur als Teil einer anderen Anleitung verwendet werden sollte.

Was du brauchst

  1. Prerequisite, Internal Hardware: Schritt 1, Bild 1 von 3 Prerequisite, Internal Hardware: Schritt 1, Bild 2 von 3 Prerequisite, Internal Hardware: Schritt 1, Bild 3 von 3
    • Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate.

    • Make sure the screws are kept in a safe place to insure they are not lost.

    • Remove the back plate.

  2. Prerequisite: Schritt 2, Bild 1 von 2 Prerequisite: Schritt 2, Bild 2 von 2
    • The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner.

    • Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.

    • Adhesive on the back side of the battery holds the internal components to the front case.

    • Use tweezers or a plastic opening tool to disconnect the ribbon cable from the motherboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team 1-7, Leahy Fall 2015 Mitglied von USF Tampa, Team 1-7, Leahy Fall 2015

USFT-LEAHY-F15S1G7

3 Mitglieder

5 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 77