Was du brauchst
-
-
Use the Phillips #0 screwdriver to remove the six outside screws. Orientation is from the front of the camera.
-
2 screws are located on the bottom.
-
2 screws are located on the left side. (HDMI port)
-
2 screws are located on the right side of the camera. (Opposite HDMI side)
-
-
-
-
To remove the back screen case, use the blue opening tool to open the case up from the right side.
-
-
-
Use screwdriver to remove control panel screw.
-
Lift up control panel from the side where the screw was just removed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team 12-4, Eyestone Spring 2016 Mitglied von USF Tampa, Team 12-4, Eyestone Spring 2016
USFT-EYESTONE-S16S12G4
4 Mitglieder
8 Anleitungen geschrieben
