Was du brauchst
-
-
Remove the four 4 mm Phillips #0 screws from the bottom of the laptop.
-
-
-
Carefully turn the laptop over and open the screen all the way.
-
Locate the slot to remove the keyboard in the lower left hand corner.
-
Using a spudger as a lever, insert it into the slot and gently pry up.
-
-
-
After the keyboard pops up, pull it away from the screen just enough to release the tabs.
-
-
-
-
Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.
-
-
-
Position the laptop so that the bottom is facing upward.
-
Remove the three 4 mm Phillips #0 screws holding the bottom of the palm rest.
-
-
-
Return the laptop to proper position and open the screen.
-
Remove the six 4 mm Phillips #0 screws holding in the palm rest.
-
-
-
Gently lift the palm rest and rotate it outward so that the bottom is now facing up.
-
-
-
Remove the 4 3 mm screws that hold the cooling fan to the system board.
-
-
-
Unplug the cooling fan wires from the system board by gently pulling on the hard molded plastic portion.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.