Zum Hauptinhalt wechseln
Deutsch
Englisch

Panasonic camera DMC FS 16 CCD cleaning

Informationen zur Anleitung

= Fertig = Unvollständig

      Beschreibe das genaue Ersatzteil oder den Bestandteil des device an dem du arbeitest. Bsp. Akku

      Einen Titel erstellen.

      Diese kurze Zusammenfassung wird nur in den Suchergebnissen angezeigt.

      Gebe Hintergrundinformationen, bevor der Leser mit der Anleitung beginnt.

      Anleitungsschritte

      1. Schritt

      Images taken with the FS16 of the same object before and after cleaning.

      2. Schritt

      Open the battery compartment cover and remove the battery and the memory card,

      3. Schritt

      Remove the two 4.6 mm # 000 Phillips screws from the bottom near the tripod thread

      4. Schritt

      Remove the single 3.3 mm # 000 Phillips screw from the right side.

      5. Schritt

      Remove the four 3.3 mm Phillips screws from the left side

      6. Schritt

      Use a spudger or plastic opener to remove the rear cover. Start next to the USB cover and slide the tool along the camera. Lift the rear housing cover off.

      7. Schritt

      Carefully lift the keyboard board vertically upwards with your fingers.

      8. Schritt

      Under the keyboard board you will find a gray plastic molding. This part is just jammed and with a bit of patience you can remove it with a spudger. Make sure that none of the sensitive detents break off. Start prying at the bottom.

      9. Schritt

      Under the gray plastic molding you will find the motherboard. You do not have to replace the ribbon cable to the display. It is enough to fold the display away!

      10. Schritt

      On the opposite side, the display is fixed with a thin piece of sheet metal. Carefully bend the metal away with tweezers or similar tool

      11. Schritt

      Under the display is another shielding plate. It is attached with two 6.4 mm #000 Phillips screws. Remove those to remove the shield

      12. Schritt

      The back of the CCD is exposed.

      13. Schritt

      Flip the CCD up.

      Deine Beiträge sind lizenziert unter der Open-Source Creative Commons Lizenz.