Zum Hauptinhalt wechseln

Hinweis: Du bearbeitest eine grundständige Anleitung. Alle Änderungen, die du vornimmst, betreffen alle 12 Anleitungen, die diese beinhalten.

Englisch
Japanisch
Schritt 2
Disconnect the camera cable by sliding it horizontally out of its socket. Pull the cable parallel to the surface of the logic board, in the direction of the optical drive. Do not pull straight up, or you will destroy the connector.
  • Disconnect the camera cable by sliding it horizontally out of its socket.

  • Pull the cable parallel to the surface of the logic board, in the direction of the optical drive. Do not pull straight up, or you will destroy the connector.

  • If you see a small plastic retainer stuck to the logic board that prevents the camera cable from sliding out, peel it up carefully from the logic board. Apply a little heat from a hair dryer or heat gun if necessary to help soften the adhesive holding it in place. Do not attempt to forcibly disconnect the cable with the retainer in place.

  • If you still have trouble, use the point of a spudger to push at each side of the connector and "walk" it slowly from its socket.

カメラケーブルの先端をまっすぐにソケットから引いて接続を外します。

小さなハードプラスチップのパーツがロジックボードに取り付けられており、ソケットからカメラケーブルが落ちるのを防いでいます。このパーツをまず取り除いてから作業を進めてください。コネクターにダメージを与えてしまいます。

ロジックボードの表面と並行してコネクターを光学ドライブ側に向けて引っ張ります。ソケットからまっすぐ上に引っ張らないでください。

-[* black] Disconnect the camera cable by pulling the male end straight away from its socket.
- [* icon_caution] There is a small piece of hard plastic stuck to the logic board that stops the camera cable from falling out of its socket. Be sure to peel this off first or you could damage the connectors.
-[* icon_note] Make sure to pull the connector parallel to the face of the logic board and toward the optical drive, not straight up from its socket.
+[* black] Disconnect the camera cable by sliding it horizontally out of its socket.
+ [* icon_caution] Pull the cable parallel to the surface of the logic board, in the direction of the optical drive. Do ***not*** pull straight up, or you will destroy the connector.
+ [* black] If you see a [https://d3nevzfk7ii3be.cloudfront.net/igi/FdbjNAIY4CP3TQZk.full|small plastic retainer|new_window=true] stuck to the logic board that prevents the camera cable from sliding out, peel it up carefully from the logic board. Apply a little heat from a hair dryer or heat gun if necessary to help soften the adhesive holding it in place. ***Do not*** attempt to forcibly disconnect the cable with the retainer in place.
+ [* black] If you still have trouble, use the point of a spudger to push at each side of the connector and [guide|25629|"walk" it slowly from its socket|stepid=64975].

Deine Beiträge sind lizenziert unter der Open-Source Creative Commons Lizenz.