Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Pull on the hood release lever just inside the passenger door to pop the hood.
-
Locate the hood release latch under the hood. Use one hand to press up on the latch while you lift the hood.
-
Insert the hood prop rod into the hole in the hood marked with an arrow.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the head light bulbs and connectors directly behind the headlights and on either side of the engine bay.
-
Detach the head light connectors by pushing on the lever on the top of the connector and pulling it straight down.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Turn the head light bulb counterclockwise and pull it straight back to remove it.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
27 weitere Nutzer:innen haben diese Anleitung absolviert.
13 Kommentare
I change both bulbs and still high beam don't work what else can be wrong
Nobody can replace the headlight for my 1999 Honda Accord (low beam). Everyone says the 9006 is supposed to fit the socket. The socket is fine; the connector for the new bulb is covered by a plastic sheath, which the old bulb doesn't have. Should I go to a dealer for this part?
Did you end up with a solution I'm having a similar issue