Einleitung
This guide demonstrates how to remove and replace fuses for your Dodge truck.
Werkzeuge
Ersatzteile
-
-
Open the hood by pulling the hood lever in the driver-side footwell.
-
Reach under the center of the grille and press the hood latch.
-
-
-
Locate the fusebox. The fusebox is the box that says "Fuse and Relay Center", near the left front fender of your Dodge.
-
Unscrew the plastic nut that holds the cover of the fusebox in place.
-
-
-
Remove the nut and the cover of the fusebox. Use the inside of the fusebox cover to determine which fuses you need to check.
-
Locate the fuse grabber. The fuse grabber is located near the front of the fusebox.
-
Remove the fuse grabber from its holder.
-
-
-
Use the fuse grabber to carefully pinch the fuse.
-
Pull the desired fuse out.
Which fuse controls the fan for the air conditioning heating unit panel in the cab of the truck
-
To replace a fuse, follow these instructions in reverse order. Make sure you buy the correct fuse to replace a blown fuse. Serious damage can occur if you do not use the correct replacement fuses.
To replace a fuse, follow these instructions in reverse order. Make sure you buy the correct fuse to replace a blown fuse. Serious damage can occur if you do not use the correct replacement fuses.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
9 weitere Nutzer haben diese Anleitung absolviert.
15 Kommentare
thanx anyway. but not the answer I wanted. didn't tell me anything about which fuse it was .I looked in the fuse box and didn't c the fuse labled headlight there...
Half of my fuse box only works.Wat could b wrong .I need help
Half of my fuse box only works.Wat could b the problem
il a tu une fusible pour la chauffrette si oui où elle est,merci
je voudrais savoir s’il a des fusibles pour la chauffrette car ce matin ma chauffrette ne marche plus merci
Where is the starter relay on a 2008? It’s not under the fuse box
are the fuse boxes the same for 2002-2008 ram 1500s? My husband needs to replace his 2008 1500 fuse box, and we found a 2005 fuse box, will that work?
How do you pull those big suckers on the right? I don’t want to put too much work to it for fear of damaging something.
Same here. That's what I was actually looking for