Einleitung
Did your headlight on your jeep recently stop working? Use this guide to replace the headlight and get driving once again.
Was du brauchst
-
-
Locate the two gray latches on either side of the hood near the headlights.
-
Pull the latches away from the hood to release the latches.
-
-
-
Reach under the hood and push the lever left to right. You should now be able to lift the hood.
-
Prop open the hood by inserting the support rod into the designated hole on the underside of the hood.
-
-
-
Locate all six push on fasteners on the top of the grill.
-
Use a flathead screwdriver to pry up the fasteners, and make sure you put the screws somewhere safe.
-
-
-
-
Locate right and left blinker lights under the fenders.
-
Twist blinker light toward the ground, and make sure you pull the bulb out carefully.
-
-
-
Make sure all fasteners are removed from top of the grill, and the top of the grill is loose.
-
Firmly pull the bottom of the grill until the grill disconnects from the jeep.
-
-
-
Locate the 4 screws holding the headlight in place.
-
Use a star bit screwdriver to unscrew the .164-18 x .625 mm star bit screws around the headlight, and make sure you place screws somewhere safe.
-
-
-
Locate red tab on the headlight plug connector, and push it away from the headlight.
-
Firmly pull the connector away from headlight to remove.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
6 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Cal Poly, Team 17-3, Green Fall 2015 Mitglied von Cal Poly, Team 17-3, Green Fall 2015
CPSU-GREEN-F15S17G3
4 Mitglieder
3 Anleitungen geschrieben
3 Kommentare
Could Jeep make it more difficult to do simple maintenance? I doubt it!
What it is the recommended torque to screw it back?
