Zum Hauptinhalt wechseln

Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.

Was du brauchst

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 1, Bild 1 von 2 : Schritt 1, Bild 2 von 2
    • Start with flipping the laptop over so that the bottom side is facing up.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 2, Bild 1 von 3 : Schritt 2, Bild 2 von 3 : Schritt 2, Bild 3 von 3
    • Remove the screw for the small panel with a Phillips #1 screwdriver.

    • Use your plastic opening tool to lift up the cover to remove it.

    • Remove the screw beneath the service cover with a Phillips #1 screwdriver.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 3, Bild 1 von 3 : Schritt 3, Bild 2 von 3 : Schritt 3, Bild 3 von 3
    • Remove the 9 screws around the perimeter of the back case with a Phillips #1 screwdriver.

    • Use a plastic opening tool to pry the back cover off of the device.

    • Remove the back cover exposing the battery.

  4. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 4, Bild 1 von 3 : Schritt 4, Bild 2 von 3 : Schritt 4, Bild 3 von 3
    • Remove the single screw securing the battery with a Phillips #1 screwdriver.

    • Gently pull the battery cable from its connector on the motherboard.

    • Lift up on the battery to remove it.

Ziellinie

2 weitere Nutzer:innen haben diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 2

Letzte 7 Tage: 26

Letzte 30 Tage: 69

Insgesamt: 4,971