Zum Hauptinhalt wechseln

AT&T NVG510 Button Replacement

Was du brauchst

  1. AT&T NVG510 Button Replacement, Reset and Wi-Fi Buttons: Schritt 1, Bild 1 von 1
    • Place the router on one side so that the rubber stands are facing upward.

    • Remove the stands from the left corners only, relative to the AT&T logo if facing upright.

  2. AT&T NVG510 Button Replacement: Schritt 2, Bild 1 von 1
    In diesem Schritt verwendetes Werkzeug:
    Flathead 3/32" or 2.5 mm Screwdriver
    $5.49
    Kaufen
  3. AT&T NVG510 Button Replacement: Schritt 3, Bild 1 von 2 AT&T NVG510 Button Replacement: Schritt 3, Bild 2 von 2
    • Pry open the case to reveal the board.

    • Some force may be required.

    • Take out the one screw located on the center-right area of the board.

  4. AT&T NVG510 Button Replacement: Schritt 4, Bild 1 von 2 AT&T NVG510 Button Replacement: Schritt 4, Bild 2 von 2
    • Lift the board slowly out of the case.

    • Be careful as to not damage the board.

  5. AT&T NVG510 Button Replacement: Schritt 5, Bild 1 von 1
    • Locate the buttons to the right of the yellow ports along the edge of the board.

  6. AT&T NVG510 Button Replacement: Schritt 6, Bild 1 von 3 AT&T NVG510 Button Replacement: Schritt 6, Bild 2 von 3 AT&T NVG510 Button Replacement: Schritt 6, Bild 3 von 3
    • Locate the silver points that connect the buttons to the board.

    • To release the buttons, use a soldering iron to heat up and melt the silver connecting points.

    • Avoid touching the solder to the board. Touch only the silver points.

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer:innen haben diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 5

Insgesamt: 561