Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Werkzeug & Ersatzteile

Ersatzteile

Keine Ersatzteile angegeben.

  1. The first thing we want to do is remove the neck from the body. This is necessary to access either the inside of the neck or the body. The round tab with a triangle can be turned by inserting a  .25" tip Flathead screwdriver and turning. Simultaneously, as the tab turns about a quarter circle, pull the neck and it should slide out with minimal force. Once the neck has been separated from the body remove the eight screws from the back of the neck with a Phillips Head 0 screwdriver. All screws are 12 mm.
    • The first thing we want to do is remove the neck from the body. This is necessary to access either the inside of the neck or the body.

    • The round tab with a triangle can be turned by inserting a .25" tip Flathead screwdriver and turning. Simultaneously, as the tab turns about a quarter circle, pull the neck and it should slide out with minimal force.

    • Once the neck has been separated from the body remove the eight screws from the back of the neck with a Phillips Head 0 screwdriver. All screws are 12 mm.

    • Next remove the four screws that were covered by the neck.

    • Finally, remove the eight screws from the back of the body.

    • This screw at the bottom of the body is a bit longer than the others.

    • With all the screws out, both the neck and the body shells should open with minimal force.

    • When separating the front and back half of the body do so carefully as the wiring from the battery pack to the components is fixed to each half with adhesive and can detach from any of the points if pulled to roughly.

  2. Manta Precision Bit Set

    112 Bits für jede Reparatur.

    Upgrade Your Toolbox

    Manta Precision Bit Set

    Upgrade Your Toolbox
  3. These are the whammy bar components, we highly recommend removing these components before working on other areas of the body as the whammy bar protrudes making it difficult to rest on a flat surface.
    • These are the whammy bar components, we highly recommend removing these components before working on other areas of the body as the whammy bar protrudes making it difficult to rest on a flat surface.

    • To remove the whammy bar, follow the steps included in the whammy bar replacement guide, found on our device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jeff Bennett

Mitglied seit: 01.02.2017

231 Reputation

2 Anleitungen geschrieben

Team

UW Tacoma, Team 2-4, Rose Winter 2017 Mitglied von UW Tacoma, Team 2-4, Rose Winter 2017

UWT-ROSE-W17S2G4

4 Mitglieder

12 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 0

Letzten 7 Tage: 2

Letzten 30 Tage: 10

Insgesamt: 309