Einleitung

Use this guide to replace the motherboard in your Altec Lansing Mini Lifejacket 2 if the bluetooth chip, microphone, or another electronic component has failed.

  1. Use the spudger to remove the eight black pins from the front and back of the wire screens.
    • Use the spudger to remove the eight black pins from the front and back of the wire screens.

    Kommentar hinzufügen

  2. Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.
    • Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.

    • Removing the secondary pins from the rubber casing is optional.

    Kommentar hinzufügen

    • Remove both black and orange layers from the speaker body.

    Kommentar hinzufügen

    • Remove the single 7.8mm Phillips #2 screw from the mounting plate located under the device.

    • Slide the mounting plate out to remove it.

    Kommentar hinzufügen

    • Pry off the wire mesh on both sides using a metal spudger.

    • Be gentle to avoid bending the mesh.

    Kommentar hinzufügen

  3. Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK an der Kasse
    Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK
    • Using tweezers, remove the four rubber stoppers in each corner of the rear panel.

    Kommentar hinzufügen

    • Remove the four 13.7mm Phillips #1 screws located underneath the rubber stoppers.

    Kommentar hinzufügen

    • Pull the case apart to access the interior components.

    Kommentar hinzufügen

    • To remove the back panel, gently pull out its wire harness.

    Kommentar hinzufügen

    • Disconnect the battery from the motherboard.

    • The battery is not secured within the case and can be removed after detaching its wiring from the circuit board.

    Kommentar hinzufügen

    • Unplug the remaining four wire harnesses attached to the circuit board

    Kommentar hinzufügen

    • Remove the three 9.1mm Phillips #1 screws located on the circuit board.

    Kommentar hinzufügen

    • Remove the motherboard.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Stephen Albrecht

Mitglied seit 14.02.2018

675 Reputation

4 Anleitungen geschrieben

Team

USF Tampa, Team S3-G2, Nance Spring 2018 Mitglied von USF Tampa, Team S3-G2, Nance Spring 2018

USFT-NANCE-S18S3G2

4 Mitglieder

4 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 6

Letzte 7 Tage: 16

Letzte 30 Tage: 71

Insgesamt: 535