Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Use this guide to replace the motherboard in your Altec Lansing Mini Lifejacket 2 if the bluetooth chip, microphone, or another electronic component has failed.
Was du brauchst
-
-
Use the spudger to remove the eight black pins from the front and back of the wire screens.
-
-
-
Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.
-
-
-
Remove the single 7.8mm Phillips #2 screw from the mounting plate located under the device.
-
Slide the mounting plate out to remove it.
-
-
-
-
Using tweezers, remove the four rubber stoppers in each corner of the rear panel.
-
-
-
Remove the four 13.7mm Phillips #1 screws located underneath the rubber stoppers.
-
-
-
Unplug the remaining four wire harnesses attached to the circuit board
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.
6 Kommentare
need back panel replacement
Same here! Loved the product. Can not afford to buy something else.
I need 2 the board for charging,usb,aux cord that plugs into motherboard.