Einleitung
Use this guide to replace the 4-in-1 WiFi/Bluetooth/FM/GPS board on the Amazon Echo Dot 2nd generation. The 4-in-1 is located on the motherboard, so the whole board must be replaced, rather than replacing each individual component.
Was du brauchst
-
-
Power off and unplug the echo
-
Using the plastic opening tool, peel off the rubber layer on the bottom of the echo
-
-
-
Use a T8 screwdriver bit to unscrew the four 1.6mm torx screws
-
Remove the black cylindrical base
-
-
-
-
Use the metal spudger to lift the ZIF connector
-
Remove the ribbon cable from the slot
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
7 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
USF Tampa, Team S1-G3, Leahy Fall 2017 Mitglied von USF Tampa, Team S1-G3, Leahy Fall 2017
USFT-LEAHY-F17S1G3
3 Mitglieder
12 Anleitungen geschrieben
2 Kommentare
Where can I find the part my dot won’t connect and I have been going crazy trying to find the motherboard
I wish to recommend not removing the adhesive layer if you plan to reassemble this Echo Dot. I would suggest poking holes to reach the four screws instead. Then reassembly can reuse the same adhesive layer.
