Einleitung
Je älter dein Kindle wird, desto schlechter wird die Akkulaufzeit des Geräts. In dieser Anleitung erfährst du, wie du den Akku deines Kindle ersetzen kannst, damit du stundenlang lesen kannst, ohne ihn so oft aufladen zu müssen.
Was du brauchst
-
-
Zwänge vorsichtig ein Öffnungswerkzeug zwischen die Rückseite und dem restlichen Gerät. Löse die Rasten, mit denen die beiden Teile zusammengehalten werden.
-
-
-
Führe das Werkzeug rund um das Gerät herum, bis alle Rasten gelöst sind.
-
An der längsten und dicksten Seite des Oasis befinden sich fünf Rasten, an den anderen keine.
-
-
-
Entferne die Rückseite vorsichtig vom Gerät.
-
Löse die Rückseite behutsam aus der Klebeverbindung. Achte darauf, dass der Kleber in so gutem Zustand bleibt, dass du ihn später nochmals verwenden kannst.
-
-
-
-
Drücke den Spudger vorsichtig von der linken Seite aus unter den Akku und arbeite langsam mit dem Spudger an der Kante entlang, um den Akku vom Klebeband zu lösen. Achte darauf, die dünne Folie auf der Rückseite des Akkus nicht zu zerreißen.
-
-
-
Hebe den Akku mit einem Spudger an und ziehe ihn langsam mit den Fingern vom Kleber ab.
-
-
In diesem Schritt verwendetes Werkzeug:Tweezers$4.99
-
Hebe das Klebeband mit der Pinzette vorsichtig vom Strombrückenanschluss ab. Wenn ein neues Gerät mit einem neuen Stück Klebeband geliefert wird, entferne es vollständig, wenn nicht, lege eine Ecke mit der Vorderseite nach unten auf eine saubere Oberfläche, um es wieder zu verwenden.
Heya, can you share the details for the battery?
-
-
-
Sobald der Kleber und die Anschlüsse entfernt sind, kannst du den alten Akku aus dem Gerät nehmen.
One step missing…. the end of the orange power connector (the end not attached to the battery) clips into a little socket which is barely visible. You can tell when it clips in by the feel and sound. Make sure that when you put the new battery in, you first clip the connector in before you stick the tape down.
Thank you @Gary Jacobson… that’s a pretty important step that’s missing. I greatly appreciated your comment noting it.
Also, folks should be aware that the battery you get from iFixIt might come fully discharged. So if your Oasis doesn’t power-on immediately (or do anything at all) after replacing the battery, don’t despair! Plug it in, let it charge for a while, and see if it comes back to life. Mine did (after I had taken it apart twice, reseated the battery and then assumed it was dead and ordered a new one from Amazon). Sigh!
-
-
-
Schließe den neuen Akku an, indem du das freie Ende des orangenen Versorgungskabel in den kaum sichtbaren Anschluss einsteckst. Du solltest es fühlen und hören, wenn das Kabel einrastet. Der Stecker muss zuerst eingesteckt sein, bevor du das Band befestigst.
-
Vorsicht: Der neue Akku ist möglicherweise noch nicht geladen, deswegen lässt sich das Gerät eventuell nicht gleich einschalten. Lade zuerst den neuen Akku deines Oasis auf.
-
Um dein Gerät wieder zusammenzubauen, befolge diese Anweisungen in umgekehrter Reihenfolge.
Um dein Gerät wieder zusammenzubauen, befolge diese Anweisungen in umgekehrter Reihenfolge.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
18 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
100%
Diese Übersetzer:innen helfen uns, die Welt zu reparieren! Wie kann ich mithelfen?
Hier starten ›
23 Kommentare
Grate explanation. where can I find the battery? couldn’t find it anywhere
thanks
Hi, same comment: great and interesting but I can’t find the battery anywhere…
You can find the battery here
https://www.nextbatteries.com/products/a...
890 mAH Li-Polymer 3.7V 61.60 x 53.32 x 2.78mm
That is not the right battery. It doesn’t even look like the one in the pictures above.
That is a Kindle 8 battery, not an Oasis 8th Gen battery.
The battery you linked is NOT made for the Kindle Oasis, which is what this guide is for.
This is not the right battery for the device.
Careful, this is not the right battery - at least not the internal battery of the Oasis 2016.
Nikkoura -
The link given was the incorrect battery. Is it available anywhere?
Did you find one? I got mine on Amazon with a little kit for about $30. It seems to be working.
Is the Kindle Oasis likely to still be waterproof after battery replacement? I can sense a bit of a gap in the plastic where I dug it open.
I don't think the original Oasis was ever waterproof.
Please help me find the battery, mine is dead
Thanks for the heads up on that Nat Whilk,
Unfortunately for me the postage cost for delivery to Australia is $US132!!!!
https://i.imgur.com/HNbLe0o.png
Probably on account of the danger of transporting LiOn
I contacted Amazon and they could not provide me with either an Amazon link or a third party and when I sent them your link they told me to order it and that they would reimburse me the postage cost.
I asked them to give that to me in writing and they did, but I am a bit iffy about dropping $AU230 and praying that they keep up their end of the bargain.
How do you take the cover off the charging cover to replace the cover battery on this Oasis?
The batter can be found on ebay https://www.ebay.com/itm/294095223324?ss...
How about kindle oasis 2/3 replacement battery ?
I used this to change my kindle battery. Very helpful. I wasn't able to open the case with th plastic pry tool. After trying and not getting anywhere, I resorted to a very small flat screwdriver. This worked! Used the plastic tool the rest of the way.
You might be able to find the battery repair kit at https://newpower99.com/products/amazon-k...
Where can I buy this battery?
[deleted] - Antwort
Where can I find the port pls?
Bobby Turner - Antwort
It would be really helpful if you could show more detail on how the backing is attached to the device, what the latching mechanism looks like in detail, and how to separate it. The technique in the photos might work on a device that has been opened a hundred times before, but on a new one, this guide doesn’t really help me to understand how to open the device.
Jesse Dhillon - Antwort
I couldn't get the back cover off with the tool for the life of me. I wound up using a small flathead screwdriver and gently rubber hammering it in at an angle near the lower left of the raised panel, where it appears there aren't any components to damage. Once one clip is off the rest come off pretty easy with the tool.
Aaron Olinger - Antwort
Agree with Aaron
Bruce McKay - Antwort