Was du brauchst
-
-
Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.
-
-
-
Pry the center of the mouse apart to separate the upper and lower housing of the boards.
-
-
-
-
Remove the wires from the white crimp headers. this will separate the upper and lower housing units of the mouse.
-
-
-
Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place.
-
-
-
The DPI button is the red push button highlighted in red.
-
To remove it, flip the board over and desolder the wires highlighted in orange.
-
Replace component with new component and resolder back in place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 1-39, Maness Winter 2014 Mitglied von Cal Poly, Team 1-39, Maness Winter 2014
CPSU-MANESS-W14S1G39
4 Mitglieder
16 Anleitungen geschrieben
