Diese Übersetzung enthält möglicherweise noch nicht die neuesten Änderungen der Original-Anleitung. Hilf mit, die Übersetzung zu aktualisieren oder sieh dir die Original-Anleitung an.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
First start by peeling off the outer rubbery covering on the bottom of the device.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
After removing the rubber covering, unscrew the five 4.9mm Phillips screws in the holes of the plastic casing.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
After unscrewing all five screws, remove the plastic casing. The back should now look like the picture shown.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
The inner metal casing is latched inside the outer white plastic shell, so insert a pry tool underneath the metal casing and pry it apart from the shell.
-
It should make a click when it comes apart.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the outer casing.
-
The exposed logic board should look like this.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Take the device out of the casing and orient it so that you can see the WiFi card.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Wires come from the three antennas and connect on the outer edge of the WiFi card.
-
Carefully pull up on the end of one of the wires to disconnect it from the motherboard.
-
Do this for the remaining two wires.
-
-
-
Die Wlan-Karte ist mit jeweils einem Clip oben und unten befestigt.
-
Nimm das Ende von einem Clip und ziehe es weg von der Wlan-Karte. Danach sollte der Clip sichtbar von der Karte gelöst sein.
-
Wiederhole das selbe beim anderen Clip.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Grasp the upper and lower ends of the WiFi card.
-
Carefully pull the WiFi card to the right.
-
Completely remove the WiFi card.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
12%
Diese Übersetzer:innen helfen uns, die Welt zu reparieren! Wie kann ich mithelfen?
Hier starten ›