Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
The USB ports are located on the back side of the monitor, below the plastic cover and metallic panel; on the lower left hand side.
-
The first step is to remove the plastic cover panel.
-
To do so, remove the three 2mm hex screws on the monitor's stand, as well as the four 2mm hex screws located on the four corners of the back plastic cover panel.
-
For additional help removing the back panel, refer to the repair guide for the LCD Main Board.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the three screws holding metal plate, one on the top in the middle, and two at the bottom by the main cable.
-
Push the metal plate towards bottom of the monitor to release it from clips and remove.
-
After popping off (removing) metal plate, you can now see all inner components, where the USB connector is on left side.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
There are two leads from the USB port to the LCD Main Board.
-
Remove the two white connectors by raising the tabs on top gently by hand or using a small pry tool.
-
Pull connectorss away from the board while tabs are lifted.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two phillips head screws on the sides of USB port, using #2 phillips head screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the single screw on the cable hold-down, using #2 phillips head screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Finally pull USB port away from monitor.
-
To insert the new USB port, simply follow these steps in reverse using your new part.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.