Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place.
-
While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.
-
Repeat the procedure described above until the rubber base has been completely removed.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four T10 Torx screws that secure the lower case to the upper case.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Carefully lift the lower case from the upper case enough to allow access to the internals of the Apple TV.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Carefully pull the hard drive data cable straight up from its socket on the logic board.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.
Ein Kommentar
This guide may make more sense as a teardown, since its not really showing any repairs or replacements.