Einleitung

Use this guide to replace the adhesive of your Apple Watch Series 2 and reseal it.

    • Apply a little bit of isopropyl alcohol (>99%) to a Q-tip or use a cleaning pad to gently remove the adhesive leftovers on top of the force touch gasket.

      • To remove the adhesive on the side where the display cables are running, fold down the display and carefully pull it away from the frame so there's enough space.

    Kommentar hinzufügen

  1. Flip the Apple Watch upside down so the display lays flat while lifting up the case.
    • Flip the Apple Watch upside down so the display lays flat while lifting up the case.

    • Remove the leftovers on the back of the display.

    Kommentar hinzufügen

    • Use a pair of tweezers to carefully remove replacement adhesive with the blue protective film from the backing paper.

    Kommentar hinzufügen

  2. Frohes Fest, frohes Tüfteln!
    Satte 12 € Rabatt auf jeden Einkauf ab 50 €. Einfach den Code FIXMAS12 am Ende deines Bestellvorgangs eingeben
    Frohes Fest, frohes Tüfteln!
    Satte 12 € Rabatt auf jeden Einkauf ab 50 €. Einfach den Code FIXMAS12 am Ende deines Bestellvorgangs eingeben
    • Hold the replacement adhesive diagonally to thread it over the display.

    • Slightly tilt the display forward so you can align the adhesive with the frame.

    • Position the replacement adhesive on top of the force touch gasket and use the pointed end of a spudger to move and press it into place.

    Kommentar hinzufügen

    • Use the pointed end of a spudger to put the battery connection plate back in its original position.

    • Reconnect the battery flex cable.

    Kommentar hinzufügen

    • Use a pair of tweezers to place the metal plate covering the battery connector back in its original position and fix it with its Tri-point #000 screw.

    Kommentar hinzufügen

    • Gently remove the protective film on top of the adhesive.

    Kommentar hinzufügen

    • Align the screen and press it down firmly onto the adhesive.

      • To further improve bonding of the adhesive you can use an iOpener to warm up the display and then press it down again for about a minute.

    Kommentar hinzufügen

Ziellinie

Dominik Schnabelrauch

Mitglied seit 23.11.2016

21.568 Reputation

109 Anleitungen geschrieben

Team

iFixit Mitglied von iFixit

Community

113 Mitglieder

7.304 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 15

Letzte 7 Tage: 108

Letzte 30 Tage: 372

Insgesamt: 359