Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Place your hand on the back of the speaker.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four 7mm screws with a Phillips #1 screwdriver.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the speaker.
-
Disconnect the white connector from the device.
-
Remove the wires connecting the frame shown by the yellow square.
-
Pull the black cord through the hole shown by the blue arrow.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Find the top 7mm J1 JIS head screws.
-
Remove the two 7mm J1 JIS head screws with a J1 screwdriver bit connected to a 60mm extension.
-
Pull the black cord through the frame.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.