Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Turn the power off and turn the netbook upside down.
-
Slide both battery catches together to release the battery.
-
Slide the battery out.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the memory compartment.
-
Using a Plastic Opening Tools, remove the screw rubber cover.
-
Remove the screw.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a Plastic Opening Tools near the screw hole to release the cover.
-
Remove the cover
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
In diesem Schritt verwendetes Werkzeug:Spudger$3.99-
Using a Spudger, push both right and left metal clip to release one of the RAM module.
-
Slide out the RAM module.
-
Do the same with the second RAM module if necessary.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the screws as necessary.
-
For top cover removing, only remove the 2 bottom screws.
-
The one short screw paterns to uper left screw hole directly on the PCB.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a Plastic Opening Tools to release the top cover.
-
Start from the left side.
-
Go around on the bottom
-
Finish with the right side.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
In diesem Schritt verwendetes Werkzeug:Spudger$3.99-
Carefully slide the top cover to the bottom in order to see the touchpad connector on the PCB.
-
Use a Spudger to slide the conector attachment black part and release the ribbon from the PCB.
-
Now you can remove the top cover
-