Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Store

Einleitung

We are going to teach you how to remove/replace the Fan and Heat Sink of your Asus U50F-RBBAG05 .

  1. Turn the laptop over so the bottom is facing up.
    • Turn the laptop over so the bottom is facing up.

    • Slide the two tabs on the bottom of the laptop toward the edges of laptop.

    • Slide the left tab to the left to lock it into the unlocked position. The red showing next to the tab signifies that it's unlocked.

    • You will have to hold the right tab to the right to keep the slot unlocked while removing the battery.

  2. Hold down the tab on the right side, then begin sliding the battery out. Remove the old battery.
    • Hold down the tab on the right side, then begin sliding the battery out.

    • Remove the old battery.

    • Next, insert the new battery into the empty slot. Release the right tab to begin locking the new battery into place. Slide the left tab to the right to completely lock the battery into the slot. The red that was showing near the left tab should be gone. This signifies that the battery is locked into place.

  3. Remove 6 screws
    • Remove 6 screws

  4. LOSGELÖST LERNEN

    Akku Fix Kits für Macs

    Fix Kits kaufen

    LOSGELÖST LERNEN

    Akku Fix Kits für Macs

    Fix Kits kaufen
  5. Pry the lower panel up with your fingernail/spudger.
    • Pry the lower panel up with your fingernail/spudger.

  6. Lift up and remove Lift up and remove
    • Lift up and remove

  7. Remove the 2 screws on the fan Remove the 4 screws on the heat sink
    • Remove the 2 screws on the fan

    • Remove the 4 screws on the heat sink

  8. Remove 1 Bundled  Cable Connector:  Pull the cable away from the connector in the same direction as the individual wires are running.
    • Remove 1 Bundled Cable Connector: Pull the cable away from the connector in the same direction as the individual wires are running.

    • Pull evenly on the full width of the cable so that no individual wires are overly strained.

  9. Pull up the heat sink a bit and then pull back (there's an overhanging piece of the lower panel near the fan that you have to scoot out of) Then lift and remove the whole device
    • Pull up the heat sink a bit and then pull back (there's an overhanging piece of the lower panel near the fan that you have to scoot out of)

    • Then lift and remove the whole device

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 1

Letzten 7 Tage: 2

Letzten 30 Tage: 4

Insgesamt: 212