Was du brauchst
-
-
Remove the following six screws:
-
Six 4 mm screws using a Phillips #0 screwdriver.
-
Remove the following one screw:
-
One 14 mm screw using a Phillips #0 screwdriver.
-
-
-
Take two rubber caps off the back side of the laptop.
-
Use a Phillips #0 screwdriver to remove the two 14 mm screws under the rubber caps.
-
-
-
-
Use a plastic or metal spudger to separate the keyboard from the back panel and lift the keyboard out of place.
How exactly does the keyboard pod out ? It doesn’t come off at the screen hinge.
Look at comments in the previous step. There are 2 more screws.
-
-
-
Remove the black foam and adhesive located on top of the hard drive.
-
-
-
Remove the following four screws:
-
Four 4 mm Phillips #0 using a phillips screwdriver.
-
-
-
Slide out the hard drive
Slide the drive to the right, away from the sata connectors at the left.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Cal Poly, Team 21-24, Maness Winter 2015 Mitglied von Cal Poly, Team 21-24, Maness Winter 2015
CPSU-MANESS-W15S21G24
4 Mitglieder
8 Anleitungen geschrieben
2 Kommentare
You FORGOT TO MENTION that one must remove the 2 Rubber feet to get at 2 more screws :-(((((((
There are also two other screws under the rubber feet above the battery.
digg1024 - Antwort
I agree. Two another 14 mm screws under the rubber feet.
shao.onii - Antwort